A tall wood-framed room with a wall of windows. Every stud bay is filled with foam.

Home / Homes and barndominiums

Spray foam insulation for homes and barndominiums in El Campo, TexasFoam before the sheetrock.

Shady Oak Spray Foam insulates new homes, barndominiums and houses you already live in, from El Campo across the Texas Gulf Coast. Open cell usually goes in the attic and the walls. Closed cell goes on steel and under the floor. Call while the framing is still open.

100% recommend on Facebook, from 6 reviews

Pictured: a house we sprayed, every stud bay and the roof deck.

Homes and barndominiums

A house gets one easy shot at its walls, the days after the rough-in and before the sheetrock, when every stud bay is still open to spray.

Usually
Open cell in attics and walls
When to call
After rough-in, before sheetrock
Lived-in homes
Attics and crawl spaces
Based in
El Campo, Texas

Where foam fits in a build

After the rough-in. Before the sheetrock.

Foam has one slot in a house build. Here’s where it lands, so you know when to pick up the phone.

  1. Stage 1

    Slab and framing

    The slab is poured and the walls and roof get framed. Nothing to spray yet.

  2. Stage 2

    Dried in

    Roof and windows go on, so the framing can dry out and stay dry.

  3. Stage 3

    Rough-in

    The plumber, the electrician and the AC crew run pipe, wire and duct through the open framing.

  4. Where we come in

    Foam

    This is us. After the rough-ins and before the sheetrock, we spray every stud bay and the roof deck.

  5. Stage 5

    Sheetrock

    The sheetrock crew hangs the walls and ceilings, and the foam is covered from then on.

An attic with foam across the whole underside of the roof deck.

Houses already built

Already living in it?

We insulate existing homes too. That’s mostly attics and crawl spaces, and on a renovation we take the old insulation out and put spray foam in its place.

Call about your house

What we spray

From the floor to the roof deck.

New build or lived in, wood frame or steel, the foam goes where the outside air gets into the house.

  • Open stud bays

    Open cell sprayed into each wall bay after the rough-in, where it expands around the wire and pipe already in the wall.

  • The roof deck

    Foam on the underside of the roof puts an attic AC unit and its ducts inside the insulated part of the house.

  • Barndominium shells

    Closed cell is the usual pick against the steel on a barndominium, the living side and the shop side under one roof.

  • Lived-in attics

    In a house you already live in, the attic is the easy place to reach, so it’s a good place to start.

  • Pier-and-beam floors

    Closed cell on the underside of the subfloor, the foam that doesn’t soak up water, for the side of the house facing the ground.

  • Remove and replace

    On a renovation the old insulation and dust come out first, because foam doesn’t bond well over either.

Our work

Houses we’ve sprayed.

Every picture here is a house or barndominium our crew sprayed, shot on the job before the sheetrock went up.

A metal building shell with house windows and doors, foam over the whole roof and walls.
A metal shell with house windows, roof and walls.
A framed room in a new house, every stud bay filled with foam, floor to ceiling.
Stud bays, filled floor to ceiling.
An attic room under a steep roof, foam down both slopes to a small gable window.
An attic, both roof slopes.
Close up of thick foam on the underside of a roof deck.
A roof deck, up close.

See all our work

Which foam

In a house, sometimes both.

Open cell where it’s dry and framed. Closed cell where the house meets the ground or the steel.

Looking down on a wood-frame wall: sheathing outside, studs drawn as boxes with a cross, open cell foam filling each bay to the depth of the studs, and a dashed line where the sheetrock goes. OUTSIDEINSIDE Sheathing Open cell foam Sheetrock goes on after Stud
Looking down on a wood-frame wall.

Open cell

Attics and walls

Lighter and softer. It expands more to fill the bay and seals the air, and it’s the cheaper of the two. It isn’t a vapor barrier, so it goes where the framing stays dry.

A crawlspace from the side: the subfloor on top, floor joists hanging under it drawn as boxes with a cross, closed cell foam sprayed under the subfloor and down the joists, and the ground below. FLOOR ABOVEGROUND Subfloor Closed cell foam Joist
A crawlspace, from the side.

Closed cell

Crawlspaces and metal buildings

Denser and firmer. It seals the air and holds back moisture better than open cell, and it costs more. It’s the usual pick under a floor and on a metal building.

Good to know

Foam in a room you live in gets covered, usually with sheetrock. That’s the building code, so plan on sheetrock once we say it’s clear.

Source: 2021 International Residential Code, section R316.4, read on UpCodes.

Open cell or closed cell: the full comparison

How it goes

How a house job goes.

Three steps, and the first one is a phone call while the framing is still open.

  1. You call

    Tell us where the house is, whether it’s a new build, a barndominium or one you live in, and send a few photos of the framing or the attic.

  2. We look

    We look at the building and what you want out of it, comfort, humidity or moisture, then tell you which foam goes in the walls, the roof and the floor.

  3. We spray

    Spray day comes once the rough-ins are done and the framing is dry. Plan on everybody being out, pets too, until the crew says it’s clear.

Have ready when you call

  • Where the house is
  • New build, barndo or lived in
  • Photos of the framing or attic

Questions we get

Straight answers.

The ones people ask before they call a foam crew, answered in plain words.

What does it cost to spray foam a house?

It depends on the house. Open cell is the cheaper foam and closed cell costs more, and some houses get some of each. Call with the location, the kind of build and photos, and we’ll give you a number for your building.

When in the build should I call you?

Call once the house is framed, earlier if you can. We spray after the plumber, electrician and AC crew finish and before sheetrock. The wood has to be dry, so a build that just got rained on may need to wait.

Do we have to leave the house while you spray?

Yes. On spray day nobody stays inside, and that goes for pets. You come back after the foam has cured and the house has been aired out. How long that is depends on the foam and the job, so we’ll tell you before we start.

Can you foam the walls of a house I already live in?

Usually only when the sheetrock is off, like during a remodel. Without opening walls, we can still get to the attic and the crawl space under a pier-and-beam floor, and that’s where we’d start.

Open cell or closed cell on a metal barndominium?

Closed cell goes against the steel. Framed interior walls on the living side can take open cell. If your roof is standing seam, check with whoever made the panels before it gets sprayed.

Do I need to tell my AC contractor the house is getting foam?

Yes, before he sizes the unit. A unit that’s too big cools a foamed house fast and leaves it clammy. A tight house also needs fresh air brought in on purpose, and that’s his part of the job.

What do I need to do before you spray my attic?

Fix any roof leak first, because foam isn’t a roof repair. Tell us if there’s a gas furnace or water heater up there. And cover or move anything in the attic you don’t want foam on.

Something we didn’t cover?

Call (210) 288-9665 and ask. It’s quicker than reading, and every building’s a little different.

Call about your house

Building a house?
Call before the sheetrock.

Tell us where it is and what stage it’s at. We’ll look at it and tell you which foam goes where.

(210) 288-9665

“Best spray foam job I’ve ever seen.”

Patrick G., on Facebook, August 2024